Licensed Electrician in Oakville, Ontario

Updated for 2026 — services, neighbourhoods and availability on this page are current for this year.

Electrician Oakville: heritage craft, modern standards

Oakville homes — and Oakville expectations — are demanding. Whether it's a careful rewire of a 1900s heritage property or a whole-home Lutron system in a new build, you want credentials and craftsmanship in equal measure:

• ESA/ECRA licence #7004060, fully insured, WSIB-covered, family-owned since 2003 — verifiable credentials, always.
• Heritage-home experience — we rewire older homes with minimal disruption to original finishes.
• Luxury automation capability — Control4 and Lutron systems designed, installed and programmed by electricians.
• One accountable Master Electrician — Irshad M. Javed stands behind every project personally.

Electrical services across Oakville

• Knob & Tube Wiring Replacement — common in pre-1950 Old Oakville and Bronte homes
• Service & Panel Upgrades — 100A to 200A and beyond
• Control4 Home Automation — whole-home control of lighting, audio, climate, shades and security
• Smart Home & Lighting Automation — Lutron keypads, dimming and scene control
• EV Charger Installation — Level 2 charging, load-managed
• Pot Light & LED Lighting — including landscape and soffit lighting
• Home Renovation Electrical, Basement Wiring, Custom Home & New Construction Wiring
• ESA Defect Correction, Smoke & CO Detectors
• Commercial: Emergency & Exit Lighting, Office Renovations, Restaurant Electrical, Retail & Store Electrical, Medical & Dental Electrical

Oakville neighbourhoods we serve

Old Oakville

The heritage homes around Lakeshore Road and the old town are full of character — and often original knob and tube or early wiring. We specialize in sympathetic rewiring that brings these homes up to code and insurability while protecting original plaster, trim and finishes. Home inspectors in Oakville are thorough; our ESA certificates pass them every time.

Bronte

Village charm meets modern living. Older Bronte homes need rewiring and panel upgrades, while the waterfront and newer infill get landscape lighting, hot tub circuits and EV chargers — often all on the same property.

Glen Abbey

Executive family homes where finished basements, home theatres and multi-EV garages are standard. Our Glen Abbey work includes service upgrades to 200A and 400A, theatre and audio pre-wiring, and whole-home lighting control.

River Oaks

Newer builds with big electrical ambitions: pools, outdoor kitchens, saunas and automation from the ground up. We design the electrical and automation infrastructure together so everything scales.

Uptown Core & Kerr Village

Midtown Oakville's condo towers and Kerr Village's restaurants form the town's most vertical electrical market. Condo owners here face the standard Oakville puzzle — board approvals, load reviews and parking-level panels — and we've guided Uptown Core residents through it many times. On the Kerr Village side, we keep the restaurant row and local shops powered and compliant: kitchen circuits, exit and emergency lighting, and after-hours service calls that don't interrupt a Friday dinner rush.

From heritage rewiring to luxury automation

Oakville's two extremes define our work here. On one end, knob and tube replacement in a heritage home is meticulous work — fishing wire through finished walls, protecting original detail, and leaving nothing visible except modern safety. On the other end, a new estate home deserves electrical designed for the next thirty years: panel capacity for future EVs and additions, pre-wiring for automation, and lighting scenes that work from a keypad or a phone.

As electricians who install automation — rather than AV technicians bolting onto existing wiring — we build both ends properly. Every job gets the same treatment: free estimate, written fixed price, ESA permit, passed inspection, real warranty.

Kitchens, renovations and whole-home upgrades

Oakville renovates at a level most markets don't, and kitchen projects here routinely involve the full electrical package: dedicated 240V circuits for induction ranges and wall ovens, under-cabinet and in-cabinet lighting, relocated panels when walls move, and pot lighting layouts designed with the designer before a single hole is drilled. The best time to involve your electrician is when the drawings are being finalized — not when the cabinets arrive.

The same planning discipline applies to whole-home projects. If you're opening walls for any reason, that's the moment to fix legacy issues: aluminum branch circuits, undersized service, missing GFCI protection, dead outdoor outlets. Opening a wall twice costs more than doing it right once, and we quote renovation electrical as a package so there are no surprise extras mid-project.

Landscape lighting and outdoor living

Oakville's lots are built to be enjoyed outdoors, and nothing extends a patio season like properly designed landscape lighting: path lights, uplighting for mature trees, step lighting on stone work, and warm soffit lighting along the roofline. Done properly it's layered, dimmable and integrated with the home's automation; done cheaply it's a string of solar stakes that die by August.

Outdoor work in Ontario has to be engineered for weather — GFCI protection, proper burial depths for low-voltage cable, and fixtures rated for Canadian winters. It also has to be planned alongside the other outdoor loads: pools, hot tubs, outdoor kitchens and EV chargers in the carriage house all draw from the same panel. We design the whole picture, pull the permits, and hand you a system that works every May without a ladder and a toolbox.

EV charging in Halton's most electric town

Oakville consistently posts the highest EV ownership rates in Halton Region — the driveways from River Oaks to Iroquois Ridge tell the story. Most home charger installations we complete here take a single visit plus ESA inspection, and the honest question is always the same: does the panel have room? On the 100-amp panels still common in older Glen Abbey and Bronte homes, we quote a load-management device or a 200-amp upgrade alongside the charger so you see the full picture once, in writing. Many Oakville households are now adding a second charger; roughing in capacity for it during the first install costs almost nothing by comparison.

West Oak Trails and Joshua Creek: the family-home wave

Oakville's newer family communities run on a predictable cycle: move in, finish the basement, add a hot tub, buy the EV — usually all within five years. Each step is electrical work, and each is cheaper planned than retrofitted. We offer whole-home electrical plans for these properties: a load assessment now, a staged roadmap for the next five years, and panel capacity sized once so every later project is straightforward. It's the same planning discipline we bring to custom builds, scaled to a family budget.

Commercial Oakville: from Kerr Village to the business parks

Oakville's commercial scene — Kerr Village's restaurants, the Trafalgar corridor's medical offices, the business parks along the QEW — depends on reliable, documented electrical. We handle restaurant kitchens, dental and medical fit-outs, office renovations and code-required exit lighting, scheduled around your hours of operation so your business never closes for our work. Property managers appreciate one licensed contractor who answers for the whole job from permit to certificate, with WSIB documentation on file.

Bundle and save on combined projects

Oakville homes tend to need several electrical projects in sequence — a panel upgrade, then the EV charger, then the hot tub circuit, then the pot-light layout. Bundling them saves real money: the panel is opened once instead of three times, one ESA permit can cover related work, and our crew books one trip instead of three. Typical savings on a panel-plus-EV-charger bundle run $300 to $600 versus booking separately, and a full-home pot-light package prices per-fixture from $40 to $59 with volume discounts. Ask for one master quote covering your next two or three projects — planning ahead is the cheapest upgrade we offer.

Surge protection and Oakville's lake-effect weather

Oakville's lakeside position means more lightning activity and more grid fluctuations than the inland suburbs — and modern homes full of electronics pay the price. A whole-home surge protector mounted at the panel costs a fraction of one fried appliance and protects everything downstream, from HVAC boards to EV chargers. It's a natural add-on whenever the panel is open, and with lake-effect storm season arriving earlier each year, it's the single cheapest insurance an Oakville homeowner can buy. Ask us to include it in any panel or charger quote.

Our process

• Free estimate — call 416-903-7166 or book online.
• Written fixed-price quote with clear scope.
• ESA permit and inspection arranged and passed.
• Clean, warranted work by our own crew — family-owned since 2003.

Why homeowners in Oakville choose Bano

• Licensed, not just experienced: Bano Electrical Services Ltd holds ESA/ECRA licence #7004060, and every job is led by Irshad M. Javed, a Licensed Master Electrician — Ontario's highest electrical qualification. Verify the licence on the ESA website; we encourage it.
• 20+ years in the trade: family-owned and operating since 2003, with heritage-rewire and luxury-automation depth rare in one contractor.
• Insured and WSIB-covered: written certificates available for homeowners, designers and property managers.
• Permits, inspections and certificates handled: work that's legal, documented and passes Oakville's thorough inspectors.
• Accountable and local: one crew covering Halton and the GTA from our Brampton base, answering our own phone.

Get your free Oakville estimate

Old Oakville rewires to River Oaks automation to Glen Abbey EV chargers — one call reaches a Licensed Master Electrician. Call 416-903-7166 seven days a week.

We also serve the wider region: Brampton, Mississauga, Vaughan, Richmond Hill, Markham, Toronto and Caledon.